Browse: Departments Dates Agencies
Docket ID: [Docket No. 2003-NM-274-AD; Amendment 39-13701; AD 2004-13-19]
RIN ID: RIN 2120-AA64
SUBJECT CATEGORY: Airworthiness Directives; Airbus Model A300 B2 and A300 B4; Model A300 B4-600, B4-600R, C4-605R Variant F, and F4-600R (Collectively Called A300-600); and Model A310 Series Airplanes
The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of August 5, 2004.
DOCUMENT SUMMARY: This amendment adopts a new airworthiness directive (AD), applicable to certain Airbus Model A300 B2 and A300 B4; Model A300 B4 600, B4600R, C4605R Variant F, and F4600R (collectively called A300 600); and Model A310 series airplanes. This AD requires an inspection to determine the part number of certain passenger/crew escape slides; and related investigative action and corrective action, if necessary. This action is necessary to prevent the failure of an escape slide to deploy during emergency evacuation, which could impede an evacuation and result in injury to flightcrew and passengers. This action is intended to address the identified unsafe condition.
SUMMARY: Airbus,
DOCUMENT BODY: [[Page 39836]]
Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public. Conclusion
We have determined that air safety and the public interest require the adoption of the rule as proposed.
We estimate that 202 airplanes of U.S. registry will be affected by this AD, that it will take approximately 3 work hours per airplane to accomplish the required actions, and that the average labor rate is $65 per work hour. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $195 per slide.
The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.
The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.
For the reasons discussed above, I certify that this action (1) is not a ``significant regulatory action'' under Executive Order 12866; (2) is not a ``significant rule'' under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration amends part 39 of
the Federal Aviation Regulations (14 CFR part 39) as follows: PART 39AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding the following new airworthiness directive:
Applicability: Model A300 B2 and A300 B4; Model A300 B4600, B4 600R, C4605R Variant F, and F4600R (collectively called A300600); and Model A310 series airplanes; equipped with Goodrich escape slides; certificated in any category.
Compliance: Required as indicated, unless accomplished previously.
To prevent the failure of an escape slide to deploy during
emergency evacuation, which could impede an evacuation and result in
injury to flightcrew and passengers, accomplish the following: Service Bulletin Reference
(a) The term ``service bulletin,'' as used in this AD, means the
Accomplishment Instructions of the following service bulletins, as applicable:
(1) For Model A300 B2 and A300 B4 series airplanes: Airbus Service Bulletin A30025A0475, dated October 3, 2003;
(2) For Model A300 B4600, B4600R, C4605R Variant F, and F4
600R (collectively called A300600) series airplanes: Airbus Service Bulletin A30025A6184, dated October 3, 2003; and
(3) For Model A310 series airplanes: Airbus Service Bulletin A31025A2165, dated October 3, 2003.
Note 1: These service bulletins reference Goodrich Alert Service
Bulletin 7A1296/7A129825A345, dated October 15, 2003, as an
additional source of service information for accomplishment of the inspection and modification.
Inspections and Corrective Action
(b) Within 180 days after the effective date of this AD: Do an
inspection to determine the part number (P/N) of the passenger/crew
door escape slides. If any Goodrich P/N 7A1298001, 7A1298002,
7A1296001, or 7A1296002 is found during the inspection, prior to
further flight, do the related investigative action, any applicable [[Page 39837]]
corrective action, and replace the slide with a new or modified
slide which has a girt with the correct P/N. Do all actions per the applicable service bulletin.
Parts Installation
(c) As of the effective date of this AD, no person may install
on any airplane a Goodrich escape slide having P/N 7A1298001, 7A1298002, 7A1296001, or 7A1296002, unless the related
investigative action and any applicable corrective action has been done per paragraph (b) of this AD.
Alternative Methods of Compliance
(d) In accordance with 14 CFR 39.19, the Manager, International
Branch, ANM116, FAA, Transport Airplane Directorate, is authorized to approve alternative methods of compliance for this AD.
Incorporation by Reference
(e) The actions shall be done in accordance with Airbus Service
Bulletin A30025A0475, dated October 3, 2003; Airbus Service
Bulletin A30025A6184, dated October 3, 2003; or Airbus Service
Bulletin A31025A2165, dated October 3, 2003; as applicable. This
incorporation by reference was approved by the Director of the
Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part
51. Copies may be obtained from Airbus, 1 Rond Point Maurice
Bellonte, 31707 Blagnac Cedex, France. Copies may be inspected at
the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW.,
Renton, Washington; or at the National Archives and Records
Administration (NARA). For information on the availability of this
material at NARA, call (202) 7416030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html .
Note 2: The subject of this AD is addressed in French airworthiness directive F2003435, dated December 10, 2003.
Effective Date
(f) This amendment becomes effective on August 5, 2004.
Issued in Renton, Washington, on June 18, 2004.
Ali Bahrami,
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 0414574 Filed 63004; 8:45 am]
BILLING CODE 491013P
FOR FURTHER INFORMATION CONTACT Dan Rodina, Aerospace Engineer, International Branch, ANM116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 980554056; telephone (425) 2272125; fax (425) 2271149.
14 CFR Part 39 40 CFR Part 52 14 CFR Part 71 33 CFR Part 165 50 CFR Part 679 26 CFR Part 1 40 CFR Part 180 47 CFR Part 73 50 CFR Part 17 33 CFR Part 117 44 CFR Part 67 50 CFR Part 648 14 CFR Part 97 33 CFR Part 100 40 CFR Part 63 50 CFR Part 622 26 CFR Part 301 39 CFR Part 111 40 CFR Part 300 50 CFR Part 660 44 CFR Part 65 40 CFR Parts 52 and 81 40 CFR Part 271 47 CFR Part 64 50 CFR Part 665 47 CFR Part 76 50 CFR Part 229 14 CFR Part 23 14 CFR Part 25 21 CFR Part 522